Aquafog 700 Installation Tips
Placement Guidelines
| DO:
Mount the fan high overhead. Allow room in front and below the fan
for the unobstructed propulsion of fog. Rule of thumb: the higher
the better! But leave at least one foot from any roofing structures. Set benchtop units up high and (or) angle the fogging head upward about 15 - 20 degree angle.
DO: Mount the fan at the intake end of a ventilated structure. In structures with mild to no ventilation, equally space out the units and propel fog the length of the structure. |
DO NOT: Mount the fan near the ground underneath tables or benches. DO NOT: Propel the fog into the wind (direction of airflow). DO NOT: Cramp the fan in tight quarters
or skinny aisle ways. |
Layout Guidelines
|
Small structures In applications requiring only one fan, mount the fan high,
centered along one wall, with fog propelling horizontally along
the length of the structure. If there is ventilation, choose
the intake end of the structure. The best location for automated
controls is behind the fan, at an easily accessible level for
monitoring. |
 |
Large structures Equally space the fans within the structure. Coverage capability
will largely depend on the distance between the fans. Lower
humidity and/or cooling requirements can allow for greater distance
between fans. Usually the maximum distance between fans would
be 24’ x 40’. |
Bench Top / Hanging Sump Installation Layout
Direct Feed Installation Layout
