Mobile Foggers Installation Tips
Aquafog-HRSM
| DO:
Place units in large, open airspaces if possible.
DO: Use the pivoting fogging head feature to propel DO: Utilize the unit's storage tank for occasional liquid chemical treatment. |
DON'T: Use HRSM in the horizontal fogging position in applications where dry floors are absolutely necessary. |
Aquafog-CRSM
| DO:
Use the pivoting fogging head feature to propel fog up high to help maintain dryness underneath commonly DO: Set the time clock to turn unit off within an hour of running out of chemical. DO: Utilize HAF fans. The use of HAF fans is beneficial, but all exterior vents, doors, etc. must be closed. DO: Operate CRSM at low GPH fogging rates. 2 GPH works best in lower greenhouses. DO: Always flush the unit, thoroughly cleaning the tank and strainer cap after each use, when re-entry period is up (especially when using powdered chemicals.) |
DON'T: Allow pre-mixed chemical to sit in the tank for any longer than necessary when unit is not in use. Some powders will settle within minutes of mixing. |
Aquafog-ORSM
| DO: Operate the unit using a pre-mixed amount of chemical in the tank for short operating periods or demonstrations.
DO: Connect the ORSM directly to a chemical metering pump for extended or continuous operation, utilizing the unit's water hose connection for a never-ending supply of fresh water. |
DON'T: Operate with flow control valve open all the way. This would produce near 3 GPH. Most odor-control applications fog at about 1-2 GPH, unless higher fog outputs are needed for dust control as well. |
